Having problems squaring the z axis with the bottom plate

Discussion in 'Tool heads & ToolChanger' started by W1EBR.Gene, Jun 13, 2020.

  1. W1EBR.Gene

    W1EBR.Gene Well-Known Member

    Joined:
    Apr 10, 2016
    Messages:
    276
    Likes Received:
    36
    I am still trying to see if the set square I have isn't square, so I have a new one on order, but I can't move the bottom of the z-axis extrusion far enough forward for my square to say that it was square with the bottom plate. Does this mean that the corner extrusions aren't properly aligned? The table I am building it on is probably not perfectly flat. Any construction hints would be greatly appreciated. Thank you.
     

Share This Page