COMPLETE Heated Bed Supports

Discussion in 'Guides, Mods, and Upgrades' started by Spoon Unit, Apr 28, 2016.

  1. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 7, 2014
    Messages:
    450
    Likes Received:
    93
    PLA is most likely fine, but if you print in high temps on the bed, they may get warm enough to start warping a bit. Nice and simple though, I like it.
     
  2. eca

    eca Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    229
    Likes Received:
    44
    IMG_20160817_223606.jpg Here are the ones I printed up. Did them in Polymax at .19 layer height. Thanks for the file!
     
    Spoon Unit likes this.

Share This Page