Heater Fault

Discussion in 'Getting Started' started by Andy Cohen, Dec 30, 2019.

  1. Andy Cohen

    Andy Cohen Well-Known Member

    Joined:
    Aug 23, 2019
    Messages:
    217
    Likes Received:
    57
    Print would not start. Dialog pops up that says I had a heater fault.
    Went to the tool and the heater, disconnected the heater and connected it to another tool's connection and the heater was fine. Next step the cables...

    The screws which hold the heater cables to the duet boards. ALL needed tightening!
    Works fine now.
     
    mhe likes this.

Share This Page