Hemera Design for CR-6 SE and CR-10 Smart

Discussion in 'HotEnds & Extruders' started by Triston Mitchell, Sep 19, 2021.

  1. Triston Mitchell

    Triston Mitchell New Member

    Joined:
    Sep 19, 2021
    Messages:
    1
    Likes Received:
    0
    Are there any plans for compatibility designs for the Hemera to fit on the CR-6 SE and the CR-10 Smart? I have the Hemera DD on 4 of my machines; (3) CR-10S Pro V2's and my custom 600mm³ which I had to design and fabricate the mounting from scratch for that one. I have been using this direct drive for a long while under many different applications and swear by its dependability, design, and durability. I would like to convert these printers in question over as well.
     

Share This Page