Hemera Ezboard vref?

Discussion in 'Troubleshooting' started by Random Testing, Sep 17, 2020.

  1. Random Testing

    Joined:
    Jun 25, 2020
    Messages:
    4
    Likes Received:
    0
    What is the recommended vref(the current setting) for the hemera on an ezboard v1.2?
    Is that the 1.197, due to the ezboard using TMC 2208?

    Kind regards

    Edit: it's currently set to 800 and not extruding properly. Even at 940 and 1000, the problem persists, though it doesn't seem quite as bad.
     
    #1 Random Testing, Sep 17, 2020
    Last edited: Sep 20, 2020

Share This Page