Hemera Firmware

Is there anyone that knows of a guide for Hemera Firmware using VS Code?

I have an Ender 3 upgraded with the new 4.2.7 silent board which does not use the Arduino build program.

Here is my history with it. I purchased the Hemera when it first came out and couldn't get it the firmware to compile. I was using the stock Ender 3 board and then the BTT V2 which require the bootloader but I couldn't get the firmware to compile without errors. I did have the BTT board working with the stock Ender hotend and extruder. The new 4.2.7 board doesn't use a bootloader. Part of the problem is that I'm not the best at problem solving the coding errors (or any programing for that matter). I have been nothing but frustrated with trying to get it set up. The Hemera hasn't even had filament ran through it yet. I was frustrated with it enough that I bought a Mosquito hotend with a clone Bondtech extruder. The clone extruder just doesn't work that well so before spending the money to buy the real Bondtech extruder and selling my Hemera, I thought I would see if I could get the firmware working but now I am back to the original issue. I'm not set on either of the hotends so whichever I can get to work will be the one I use.

Any help would be appreciated.

 

Thanks for the reply. It may be that I'm just putting in the changes wrong. I just can't get VS Code to compile the changes listed in the tutorial without errors. I'm leaning towards sticking with the Mosquito and will be ordering the BMG-M extruder