Hemera not extruding because faulty gear

Discussion in 'Troubleshooting' started by user64x, Aug 20, 2020.

  1. user64x

    user64x Member

    Joined:
    Aug 8, 2020
    Messages:
    2
    Likes Received:
    0
    My E3D Hemera stopped extruding last week. I noticed the middle gear of the drive train is not moving. So I disassembled it. It turned out the middle gear of the drive train is very loose. It is not moving the other half of the dual drive.

    Can we get a replacement part for this?

    I have uploaded the video of this diagnosis here.

     

Share This Page