Hemera Nozzle Offset

Discussion in 'HotEnds & Extruders' started by MrChuck, Mar 10, 2021.

Tags:
  1. MrChuck

    MrChuck New Member

    Joined:
    Mar 10, 2021
    Messages:
    1
    Likes Received:
    0
    Hi guys. Just successfully installed a Hemera on my Sidewinder X1. All went well, except for one issue. When my printer does a nozzle purge it does so off the left side of the bed. I'm assuming that's because the nozzle is now in a different position than it was stock. I'm not sure where in the firmware I can correct this. I'm using Marlin 2.0 and if anyone could point me in the right direction I would be very grateful.
     
  2. budhi

    budhi Member

    Joined:
    Mar 19, 2021
    Messages:
    2
    Likes Received:
    0
    I have seen the option of nozzle offset in the slicer, it is under 'maschine settings' in cura for example
     

Share This Page