I ordered the Hemera for my Ender 3 Pro and I'm in the process of getting the parts printed whilst I wait for it to arrive. I've ran into a few issues... So there appears to be two guides that both state they should work for the Ender 3.. The first is aimed at the Ender 3 V2. I Printed the parts but unfortunately one of the screw holes doesn't line up with the mounting plate... I guess the V2 and the Pro have a slightly different plate? The second is aimed at the CR-10. This plate fits better (if a little bulky) but half way down the page it says "8.2 Optionally gather a Bl touch".. and that's the last you hear of it. There also doesn't seem to be a place to mount a Bl touch on the printed part so I guess it was copied over from another guide? Unless I'm missing something? I'm getting a tad annoyed with printing things that don't fit so does anyone have a better solution?