Hemera poor print results, need Cura settings.

Discussion in 'HotEnds & Extruders' started by BennoDXB, Feb 28, 2020.

  1. BennoDXB

    BennoDXB Member

    Joined:
    Feb 27, 2020
    Messages:
    4
    Likes Received:
    0
    I have spent so many hours trying to get this thing printing nicely. As it stands I cannot achieve a result as good as with the stock ender 3 bowden extruder. This is obviously super disappointing as the thing cost me nearly as much as the entire printer.

    Anyway, does anyone have a cura profile that works. I cannot get a decent retraction result, so much stringing no matter what i try. I tested between 0.5 and 1.5 mm at 25 or 35 mm /s. I have linear advance set up, I have disabled the settings that i think are supposed to be disabled on that but there could be something missing.

    Stringing is not the only issue, but its the one that has taken up the most of my time.

    I cant understand why E3D hasnt provided profiles for the major slicers for various filament types.

    Anyway, thanks for any help.
     
  2. Daniel Rock

    Daniel Rock Well-Known Member
    Staff Member

    Joined:
    Jul 9, 2018
    Messages:
    97
    Likes Received:
    10
    Hi Benno,

    Can you post some images of your setup?
     
  3. BennoDXB

    BennoDXB Member

    Joined:
    Feb 27, 2020
    Messages:
    4
    Likes Received:
    0
    Sorry, I did not receive a notification about a reply.

    What setup do you mean? Physical or Cura?
     

Share This Page