Hemera stepper motor swap

Discussion in 'HotEnds & Extruders' started by Trent Tolbert, Jan 19, 2021.

  1. Trent Tolbert

    Trent Tolbert New Member

    Joined:
    Jan 19, 2021
    Messages:
    1
    Likes Received:
    0
    Is it possible to swap the stock stepper from the Hemera with a slimline stepper?

    I use an Anycubic i3 Mega S and am using the Hemera to convert to direct drive. With the stock stepper motor I lose around 10-15 mm of build volume in the X axis. With the slimline motor I would get that back.

    If anyone has any other ideas on using this with my printer, I am open to suggestions.
     

Share This Page