Hemera Vulcano

Discussion in 'HotEnds & Extruders' started by Philipp, Dec 12, 2019.

  1. Philipp

    Philipp Member

    Joined:
    Feb 3, 2018
    Messages:
    3
    Likes Received:
    1
    Did somebody use the Hemera with a Vulcano Hotend and bigger nozzles (0.8-1.2mm)?
    As there is no specs for the motor i am not sure if it has enough speed to drive the filament fast enough.

    regards

    Phil
     
  2. Daniel Rock

    Daniel Rock Well-Known Member
    Staff Member

    Joined:
    Jul 9, 2018
    Messages:
    97
    Likes Received:
    10
    Hi Phil,

    Yes, you can use the Volcano with Hemera, the motor was spec'd to be able to print with the supervolcano so you won't have any issues with it being underpowered.
     

Share This Page