Hey there, I just bought a V6 Gold editon with everything nice. :-D I installed it on my DIY Printer - the Idea comes from Prusa i3 but it's full metal. Verything looks good but I can't push the filament thru. I checkt my extruder it skipted a few stepps, till I changed the A. Now this is working fine. But I still can't psu enougth filament thru by hand. I am using: V6 Gold - pre assabled in hope it's plug n print ABS+ 1.75 30 Watt heater NEMA 17 without gears I only achived to push maybe 2 cm of "printed" filament thru the nozzle thats it. And I even tried 260°c - it should do fine at 220 - 230.
I think I found my problem. I used the temperature sensor 55 in Marlin. Now I changed to 5. My hotend was just too cold I think.... Sorry what a shame. But maybe you can tell me if sensor 5 is right?
Assuming you're using the standard supplied thermistor, then #define TEMP_SENSOR_0 5 is correct for Marlin. https://e3d-online.dozuki.com/Guide/V6+Marlin+Configuration/5?lang=en