High resolution

Discussion in 'E3D-v6 and Lite6' started by Ralph Hilton, Sep 23, 2014.

  1. Ralph Hilton

    Ralph Hilton Well-Known Member

    Joined:
    Feb 27, 2014
    Messages:
    46
    Likes Received:
    0
  2. Sanjay

    Sanjay Administrator
    Staff Member

    Joined:
    Feb 27, 2014
    Messages:
    125
    Likes Received:
    118
    I've played down at around 50micron layers with the 0.25mm nozzles with good results. I've not tried pushing it much further than that, just never had the need to do so. I'd quite like to get some nozzles made up in some obscenely small diameters to see how things go with them.

    I don't know at what point the XYZ resolution, or the E/steps resolution start coming into play, and expect that accuracy would need to be improved before practically seeing any benefits from increasing resolution.
     

Share This Page