High Temperature Dual Extrusion

Discussion in 'Multi-Extrusion' started by Jeremy Wang, Jan 29, 2018.

  1. Jeremy Wang

    Jeremy Wang New Member

    Joined:
    Jan 29, 2018
    Messages:
    1
    Likes Received:
    0
    I used an E3D-V6 to print some materials at 400C a few weeks ago. I was wondering if the Chimera hot end could also reach those temperatures without much issue. I think I remember reading some posts about the heat sink not being able to dissipate enough heat with two heat sources. Would I need to install some sort of water cooling system if I wanted at least one nozzle at 400C?
     
  2. Antoine

    Antoine Well-Known Member
    Staff Member

    Joined:
    Apr 3, 2017
    Messages:
    102
    Likes Received:
    18

Share This Page