Hobb-Goblin 8mm Hobbed Shaft: Suggested Extruder Design?

Discussion in 'General' started by Kentxu, May 19, 2015.

  1. Kentxu

    Kentxu New Member

    Joined:
    May 19, 2015
    Messages:
    1
    Likes Received:
    0
    Hello All,

    Any suggestions on which extruder design is suitable for the 8mm Hobbed Shaft?
    I would like to use it with a NEMA17 motor and for 1.75mm bowden feed.

    I'm looking for something like: "Greg's Wade reloaded extruder"
    http://www.thingiverse.com/thing:18379
    But for bowden feed.

    Thanks, Ken
     
  2. Sanjay

    Sanjay Administrator
    Staff Member

    Joined:
    Feb 27, 2014
    Messages:
    125
    Likes Received:
    118

Share This Page