Hot End Heating Issue

Discussion in 'Build Help' started by Luther, Apr 28, 2017.

  1. Luther

    Luther New Member

    Joined:
    Apr 30, 2016
    Messages:
    1
    Likes Received:
    0
    Hey Guys,

    So I got some EDGE Filament today and set the head to 240C like it says but the printer only holds it there for about 7 minutes then it just drops off.

    Screen Shot 2017-04-28 at 5.59.40 PM.png

    I've done the PID tuning.

    It seem to be fine at 210C but not 240C.

    Any ideas what could be causing this?
     
  2. Bluemalu

    Bluemalu Well-Known Member

    Joined:
    Mar 17, 2014
    Messages:
    95
    Likes Received:
    6
    Is it your cooling fan kicking in?

    When you carried out your PID tuning, did you carry it out in the middle of your bed, 4mm'ish off your heated bed with the part cooler running?

    This is where the socks work really well.
     

Share This Page