hotend can rotate is it normal

Discussion in 'Titan' started by Polpo, Jan 19, 2020.

  1. Polpo

    Polpo Member

    Joined:
    Aug 8, 2019
    Messages:
    2
    Likes Received:
    0
    I finished assembling a direct Titan following instructions , is it normal that even with all the screws tightened the hot and can freely rotate on his major axis?
    The hotend and Tiatn are orginal E3D but this situationis far from perfect and surely will cause some ringing
     
  2. mhe

    mhe Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    279
    Likes Received:
    77
    Do you mean the small heater block below the heatsink?
     
  3. Polpo

    Polpo Member

    Joined:
    Aug 8, 2019
    Messages:
    2
    Likes Received:
    0
    Nope all the hot end rotate inside the titan slot even if with plastic transparent cover tightened
     
  4. Scott C Anderson

    Joined:
    Dec 27, 2020
    Messages:
    2
    Likes Received:
    0
    I have the same issues... is this normal? Has anyone else resolved this or understand why the V6 hot end can completely rotate free inside the Titan extruder???
     

Share This Page