Hotend fan causes warping ABS

Discussion in 'E3D-v6 and Lite6' started by ajdemoed, Apr 24, 2015.

  1. ajdemoed

    ajdemoed New Member

    Joined:
    Apr 24, 2015
    Messages:
    1
    Likes Received:
    0
    I got a RepRap Prusa I3 with a E3D V6 hotend installed.
    It works fine but when I print larger objects I see warping on the side of the hotend fan probably because it gets cooled on that side...
    I print ABS 235C and 90C for the heated bed.
    Is there a solution to this. Maybe lower the speed of the fan?
     

Share This Page