How much torque to fix the Heat Break in the Heat Sink

Discussion in 'HotEnds & Extruders' started by kuhnikuehnast, May 3, 2020.

  1. kuhnikuehnast

    kuhnikuehnast Member

    Apr 9, 2018
    Likes Received:
    Hi there,
    Since I had to fight with filament pudding several times due to loosened connections, I wanted to set everything right this time. The nozzle is fixed in the heat block with a torque of 3 Nm. But with how much torque do I screw the heat break into the heat sink? I just found out by breaking the Heat Break that the same 3 Nm are too much ;-)

Share This Page