SOLVED Hybrid Dual V1.1 cable confusion

Discussion in 'Build Help' started by cez, Aug 29, 2016.

  1. cez

    cez Well-Known Member

    Joined:
    Apr 4, 2016
    Messages:
    105
    Likes Received:
    19
    In the build manual it says..

    'Select the small Cable Group, this group is for the right Extruder.

    The larger group has the extra wires for the X-Axis Endstop and the IR Sensor Probe Cable'

    However you can see in the picture, the x axis Endstop is with the bowden cable group ( i assume this is left) and the IR sensor is grouped with the direct cables (i assume this is the right) the bunch with the motor cable included)

    This is making it hard for me to figure out what bunch of cables the manual is refering to. As the larger group of cables for me is leading to the right extruder (direct) and the smaller to the left.(bowden)

    As far as the build manual goes do i just assume when it says right hand extruder im plugging in the bunch of cables leading to the direct side? the larger group with the motor cable included.

    [​IMG]
     
  2. cez

    cez Well-Known Member

    Joined:
    Apr 4, 2016
    Messages:
    105
    Likes Received:
    19
    Problem solved, many thanks :)
     

Share This Page