IDEX Rumba Wiring help needed

Discussion in 'Calibration, Help, and Troubleshooting' started by Jaysen DAYDREAMn, May 8, 2019.

  1. Jaysen DAYDREAMn

    Jaysen DAYDREAMn Well-Known Member

    Joined:
    May 11, 2016
    Messages:
    97
    Likes Received:
    9
    Hi can anyone help me with a pic of wiring on the rumba for IDEX?
    I am building Greg's aero IDEX with linear rail.

    Thank you!
     
  2. Rob Heinzonly

    Rob Heinzonly Well-Known Member

    Joined:
    Sep 20, 2015
    Messages:
    448
    Likes Received:
    174
    Hi Jaysen, this is the initial Rumba Bigbox wiring. I do recall it doesn't differ that much with IDEX.

    [​IMG]
     
    Jaysen DAYDREAMn likes this.
  3. gonzalo

    gonzalo Well-Known Member

    Joined:
    Mar 17, 2016
    Messages:
    258
    Likes Received:
    146
    All you do for IDEX is use the Xmax Endstop for the right extruder, and E2 for the right X motor. I have both part cooling fans connected together because I don’t know if you can wire it any different but that should be it.
     
    Jaysen DAYDREAMn likes this.

Share This Page