Inconsistent infill

Discussion in 'E3D-v6 and Lite6' started by Igor Tomiatti, Oct 26, 2017.

  1. Igor Tomiatti

    Igor Tomiatti New Member

    Joined:
    Aug 23, 2017
    Messages:
    1
    Likes Received:
    0
    I'm having a problem with the infill and top layer in my 3d prints. I did a test with 95% infill rectilinear, and the infill is inconsistent.

    Instead of appearing gaps with a certain pattern, it seems that some parts get thinner than others.

    The steps of the extruder are not 100% configured, as I could not because of these faults. Since this inconsistency also appears with the infill in 100% in some parts of the piece.

    Here is a picture with the infill at 45 degrees:

    [​IMG]

    I also tested the infill lines along the X and Y axes, respectively:

    [​IMG]

    [​IMG]

    Does anyone have any idea what the problem might be?
     

Share This Page