Infrared Differential Height Sensor + RAMPS / Mega 2560

Discussion in 'General' started by Andrew Brooks-Davis, Feb 7, 2019.

  1. Andrew Brooks-Davis

    Andrew Brooks-Davis New Member

    Joined:
    Feb 7, 2019
    Messages:
    1
    Likes Received:
    0
    Hi all,

    I used to have an IR differential height sensor that I could never fully get bed levelling to work so I shelved it (It ended up becoming damaged anyways due to accidentally shorting it)

    I have recently re-purchased one and it arrived together with my lovely X Nozzle :D

    Now, can anyone offer the best setting to use when programming my Mega 2560 to use it.

    Which bed levelling should I be using?

    My print bed is 200mmx200mm. Is there a default code I can drop in when programming and then just adjust the IR sensor position offsets?

    Id really appreciate any help as I once had it work then an update broke it, but it was so long ago I cant remember what settings I actually used.

    If any one is interested, im including a copy of the configuration.h from my current setup. This is without any IR sensor bneing used, just mechanical Z endstop.

    Id be super appreciative for any assistance the community can offer.

    Thanks!
     

    Attached Files:

Share This Page