Internal Nozzle Geometry Suggestions

Discussion in 'Feedback' started by gixxer, Dec 19, 2014.

  1. gixxer

    gixxer Member

    Joined:
    Dec 19, 2014
    Messages:
    2
    Likes Received:
    0
    Hi all,

    I was hoping you and E3D would like to comment on a thread on the Ultimaker forum that I've posted. Relating to internal nozzle geometry and how it could possible improve clogs / jams.

    http://umforum.ultimaker.com/index.php?/topic/8732-research-into-internal-nozzle-geometry/

    I'd like to get some feedback on what research has been done on the nozzle internal design. Its my guess that any change would benefit all metal hot ends primevally.

    This may be of interest to those with an Ultimaker 2. Both myself and Anders Olsson have come up with very similar mods to the UM2 heater block to fit the E3D nozzles. Although Anders is much further down the line than me.

    http://umforum.ultimaker.com/index....eater-block-to-fit-e3d-nozzle-on-ultimaker-2/
     

Share This Page