Is ColorFabb XT ok to print lower X carrage

Discussion in 'Build Help' started by Miasmictruth, May 10, 2016.

  1. Miasmictruth

    Miasmictruth Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    758
    Likes Received:
    112
    I know a lot of people have been using ColorFabb HT but its harder for me to get a hold of that. Will XT be ok or will it end in disaster?
     
  2. Falc.be

    Falc.be Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    244
    Likes Received:
    38
    Yes, it basically the same as edge.

    My spare parts are also in XT, 1.1 parts are in xt-cf20

    The high temp parts are HT though. Don,t know how crucial that is
     
  3. Pierce

    Pierce Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    249
    Likes Received:
    67
  4. Falc.be

    Falc.be Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    244
    Likes Received:
    38
    I have an XT fan duct right next to the nozzle on my ultimaker and never had any problems with it ( except when the peek melted and the whole hotend fell out onto the duct )
     
    Pierce likes this.

Share This Page