Issue tracker closed on marlin repo

Discussion in 'BigBox General Chat' started by Dr Jeep, Jun 5, 2016.

  1. Dr Jeep

    Dr Jeep Well-Known Member

    Joined:
    Sep 12, 2015
    Messages:
    530
    Likes Received:
    169
    Hi guys/Alex (I guess mostly)

    Issue tracker is closed for the marlin repo at https://github.com/BigBox3D
    is that intentional/by design and if so where do I post the problems I have found with the Pro branch ?
     
  2. Dr Jeep

    Dr Jeep Well-Known Member

    Joined:
    Sep 12, 2015
    Messages:
    530
    Likes Received:
    169
    Done a pull request now
     
  3. Alex9779

    Alex9779 Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    2,405
    Likes Received:
    731
    Hmmm didn't realize... But I think Greg was not finished with putting the configs up.
    He changed the repo design this weekend, ditching the second and start working with branches.
    And he came from "all for dual with comment for pro". Think he wasn't finished yet.
    Hybrid-Pro doesn't compile yet, some limits are not set correct...

    We see what he puts up Monday or Tuesday, thanks for the PR so...
     
  4. Dr Jeep

    Dr Jeep Well-Known Member

    Joined:
    Sep 12, 2015
    Messages:
    530
    Likes Received:
    169
    yeh I think maybe branches was me moaning at him over email :)
     
  5. Dr Jeep

    Dr Jeep Well-Known Member

    Joined:
    Sep 12, 2015
    Messages:
    530
    Likes Received:
    169
    On that PR there are some other things around offsets that I've left as the dual ones...I figure they are safer and I dunno WRT titan what's right and what's wrong as I only have a Pro with the original extruder I can't confirm either way.

    The Z height before homing thing I think is probably wrong (in my opinion) across the board...not sure why that has been disabled, I think perhaps someone messed up because the old setting was depreciated after RC3 as I can't think of a good reason for turning it off
     
  6. Alex9779

    Alex9779 Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    2,405
    Likes Received:
    731
    Probably he missed it, Marlin in RC3 did that automatically, that setting is new...
     

Share This Page