Hi! I'm thinking of upgrading the Kraken and purchasing the v6 Heater Block & Fixings: http://e3d-online.com/E3D-v6/v6-Spare-P ... ater-Block and screwing it right on to the Kraken Heat Break.. will this work??
The v6 block is 1.5mm bigger in one direction, but I don't think that's a problem. Otherwise, you should be good to go.
So, I got my Kraken Heat Break and v6 Heater Block in the mail and I screwed it all together, and it looks like there's a bit of a length issue: the nozzle can't be fully screwed in unless the heat break isn't and vice versa. I figured a 50/50 option is best, like in the pictures attached. What do you think? Or is is best to have the nozzle screwed in 100%?
You're not supposed to screw either in fully. Nozzle goes in fully then back out a quarter turn, heatbreak in until it stops, heat up, tighten.