Kraken Instructions?

Discussion in 'Multi-Extrusion' started by terrymisu, Jul 26, 2014.

  1. terrymisu

    terrymisu New Member

    Joined:
    Jul 26, 2014
    Messages:
    1
    Likes Received:
    0
    I know that folks on the forum feel pretty comfortable with the Kraken, but are there detailed pictures, videos, or instructions for setting up the Kraken?

    I've got the basics finished, but I'm honestly a bit confused about how to install the thermistors, and I noticed that the heads move around a bit even after tightening down the grub screws.

    Has anybody done a detailed how-to?

    Thanks!
     
  2. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    586
    Likes Received:
    91
    Thermistor install is same as on v5.

    Are the heat breaks moving after tightening the grub screws, or are the blocks the only bits moving?
     

Share This Page