Kraken Measurement question

Discussion in 'Multi-Extrusion' started by dping28, Feb 1, 2015.

  1. dping28

    dping28 Member

    Joined:
    Dec 28, 2014
    Messages:
    8
    Likes Received:
    0
    I am designing a mount for my Kraken that I ordered. (Cant wait to get it!) I saw the drawings in the Documentation section however I need a measurement that I cant figure out from them. What is the height of the Kraken with the nozzles installed? I know they can be adjusted some so lets say minimum height. Thanks!
     
  2. dping28

    dping28 Member

    Joined:
    Dec 28, 2014
    Messages:
    8
    Likes Received:
    0
    In case anyone else is curious, mine ended up roughly 39.44mm from the top of the block to the bottom of the nozzle at its minimum. I was just curious so when I designed my mount I wanted to make sure I didnt loose (Possibly gain some) any height in my Z axis.
     

Share This Page