Kraken question

Discussion in 'Multi-Extrusion' started by mrcs, Oct 28, 2016.

  1. mrcs

    mrcs Member

    Joined:
    Jul 4, 2014
    Messages:
    2
    Likes Received:
    0
    Hey guys,

    i bought a Kraken and i really like it, but im facing some problems because i want to use it as an direct drive / bowden hybrid. The space is very limited and thats i wanted to know if its possible to replace the existing cooling fixings with 90° angled ones.

    Also im curious if someone here already used the Kraken with a closed loop watercooling System like those in PCs.

    Best Regards
    Marc
     
  2. mrcs

    mrcs Member

    Joined:
    Jul 4, 2014
    Messages:
    2
    Likes Received:
    0
    Can´t anybody help me? Can you tell me which diameter the fittings are?
    Is it 1/4", 3/8" or 7/16" thread?
     
  3. David Kennedy

    David Kennedy Member

    Joined:
    Feb 28, 2016
    Messages:
    2
    Likes Received:
    0
    Hello Marc.
    I moved one of the fittings to the side. I'm not certain , but the fittings look like they are 1/8 BSP. I've mounted a Titan just above one of the back nozzles using approximately 2 inches of ptfe tubing.
     

Share This Page