Layers not sticking

Discussion in 'Calibration, Help, and Troubleshooting' started by Josh C., Aug 17, 2016.

  1. Josh C.

    Josh C. Member

    Joined:
    Jun 30, 2016
    Messages:
    17
    Likes Received:
    0
    Hi E3D Members, we have had our printer (A BigBox Dual) for a while and it has been working perfectly. But in the past couple of days the layers on our prints have not been sticking. Our right extruder isn't currently working and we tried to print a replacement dual direct mount and i was wondering what material and print setting are used for that part.

    Thanks,
    Josh​
     
    #1 Josh C., Aug 17, 2016
  2. Henry feldman

    Henry feldman Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    969
    Likes Received:
    390
    What filament are you using? PLA? Edge? ABS? Often this is because the filament is hygroscopic and is now wet.
     
    #2 Henry feldman, Aug 17, 2016
    mike01hu likes this.
(You must log in or sign up to post here.)

Share This Page