LED light wiring

Discussion in 'BigBox General Chat' started by TstarkEngineering, Apr 3, 2017.

  1. TstarkEngineering

    TstarkEngineering Well-Known Member

    Joined:
    Jan 29, 2016
    Messages:
    450
    Likes Received:
    120
    I bought LED strip wiring and am currently using just a 110 plug, is there a way to wire it up to rumba or power supply directly instead?
     
  2. Kanedias

    Kanedias Well-Known Member

    Joined:
    Sep 12, 2015
    Messages:
    406
    Likes Received:
    124
    yes, I have my LEDS wired straight to the PSU. Or you can take 12v from the Rumba board and I think there's a way to turn LEDs on and off using gcode or a octoprint plugin.
     
    Alex Stevenson likes this.
  3. Henry feldman

    Henry feldman Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    969
    Likes Received:
    389
    Mine is powered off the main PSU without any problems (I have 4 strips). I ran a wire up the back wire stack and each of the 4 strips takes a lead off that so if one fails (had it happen) the others are in parallel.
     

Share This Page