Lite 6 can not go ever 220C

Discussion in 'E3D-v6 and Lite6' started by jacob blocker, Apr 27, 2016.

Tags:
  1. jacob blocker

    jacob blocker Member

    Joined:
    Apr 27, 2016
    Messages:
    3
    Likes Received:
    0
    I have the lite 6 and when i want to print abs i cant because the hotend can not get over 220C
     
    #1 jacob blocker, Apr 27, 2016
  2. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    631
    Likes Received:
    101
    Do you have a fan blowing near the nozzle?
     
    #2 elmoret, Apr 27, 2016
  3. jacob blocker

    jacob blocker Member

    Joined:
    Apr 27, 2016
    Messages:
    3
    Likes Received:
    0
    no, i do not have one on the nozzle only the stock fan on the heat sink
     
    #3 jacob blocker, Apr 28, 2016
  4. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    631
    Likes Received:
    101
    Then I would guess that either your heater has a resistance that is incorrect for your setup, or there is a limitation in your printer's firmware.

    When you performed the resistance check in E3D's assembly instructions, what resistance did you measure?
     
    #4 elmoret, Apr 28, 2016
  5. jacob blocker

    jacob blocker Member

    Joined:
    Apr 27, 2016
    Messages:
    3
    Likes Received:
    0
    where would you find this?
     
    #5 jacob blocker, Apr 28, 2016
  6. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    631
    Likes Received:
    101
    #6 elmoret, Apr 29, 2016
(You must log in or sign up to post here.)

Share This Page