Lite6: failed to reach 240°C for heat tightening

Discussion in 'E3D-v6 and Lite6' started by Perry Ismangil, Dec 9, 2017.

  1. Perry Ismangil

    Joined:
    Nov 30, 2017
    Messages:
    3
    Likes Received:
    0
    I'm up to heat tightening step on the guide

    https://e3d-online.dozuki.com/Guide/Lite6+Assembly/2?revisionid=HEAD#s36

    I'm unable to reach 240, heating failed. It reaches about 200.

    On the PID Autotune step before I did M303S210 because I'll be printing mostly at that temp.

    That was successful.

    Unable to reach 240 I thought I shall redo PID with S240, but now PID failed, timeout.

    What are the next steps in troubleshooting?
    [​IMG]
     
    #1 Perry Ismangil, Dec 9, 2017
    Last edited: Dec 10, 2017

Share This Page