Live Z axis adjustment

Discussion in 'Calibration, Help, and Troubleshooting' started by Duncan Chivers, Oct 7, 2016.

  1. Duncan Chivers

    Duncan Chivers Well-Known Member

    Joined:
    Apr 19, 2016
    Messages:
    103
    Likes Received:
    5
    I know it's posted somewhere, but I can't find it - can you adjust the Z axis offset whilst printing?
     
  2. Alex9779

    Alex9779 Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    2,405
    Likes Received:
    731
    This is known as "Babystepping" but deactivated in the official firmwares.
    At least RC7 has an additional option for Z only, "Bed offset" I think in Tune menu while printing and in Motion menu when not, I can't remember if that was there in RC6...
     
  3. Duncan Chivers

    Duncan Chivers Well-Known Member

    Joined:
    Apr 19, 2016
    Messages:
    103
    Likes Received:
    5
    Thanks Alex, I'm on RC6 so I'll take a look.
     

Share This Page