m999 ??

Discussion in 'E3D-v6 and Lite6' started by KNM3D, Oct 27, 2015.

  1. KNM3D

    KNM3D Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    214
    Likes Received:
    8
    do I need to wire a new thermistor on my v6?
    im using it on my solidoodle 3.

    I wanted to try simplify3D tonight but I threw the m999 error to restart.
    whats the fix for this, because it does it on my rep host too.

    im thinking I just need to replace my thermistor.

    any ideas thankyou,
    I would have posted this up on soliforum but figured Id get quick responses here too.

    thankyou,
    Ryan.
     
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 7, 2014
    Messages:
    450
    Likes Received:
    93
    You might not even need to replace the thermistor. Is it reading high or low?

    If 0, there's an open circuit somewhere.

    If high (350+) then there's a short circuit somewhere. Find the fault.
     
  3. KNM3D

    KNM3D Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    214
    Likes Received:
    8
    unplugged and pluged the therm in and it works. yippy but my SD3 is printing horribly. circle arnt circles.
    I think I need to tighten my belts. not sure though.

    I cant wait till I get my big box.
     

Share This Page