Makibox v6 lite firmware

Discussion in 'E3D-v6 and Lite6' started by numloxx, Apr 10, 2015.

  1. numloxx

    numloxx Member

    Joined:
    Apr 10, 2015
    Messages:
    3
    Likes Received:
    0
    Hi all,

    I've installed a v6 lite hotend into my Makibox but the temp shows 736deg C.
    I'm running Windows 7 and I'm unsure as to how to compile the firmware.
    I did find some for the printed called 5dprint_D8_104GT-2_v2_20_42.
    I can't recall what the temp was before flashing the new firmware.
    Is there a precompiled firmware for the Makibox and V6 Lite?

    Sorry if these are noob questions, I'm still trying to learn everything.
     
  2. numloxx

    numloxx Member

    Joined:
    Apr 10, 2015
    Messages:
    3
    Likes Received:
    0
    Never mind.. I did something very silly..
    When wiring the thermistor, I crimped both, but the heatsink covered both... in other words shorting it out lol.
    Have re-wired and all up and running. LOL.. what a noob mistake.
     

Share This Page