Making right Extruder and hot end 0

Discussion in 'Guides, Mods, and Upgrades' started by Kenneth A Valentine, Sep 30, 2016.

  1. Kenneth A Valentine

    Kenneth A Valentine Well-Known Member

    Joined:
    Feb 21, 2016
    Messages:
    103
    Likes Received:
    9
    This has probably been asked before, Is there instruction to mirror or swap left extruder and right extruder so 0 is 1 and 1 is 0 or is there firmware.I did it when first got BB but mother board burned out and I can't remember how I did it at all, mind is going LOL . :rolleyes:
     
  2. A Dragon In A Pie Costume

    A Dragon In A Pie Costume Well-Known Member

    Joined:
    Jul 6, 2016
    Messages:
    213
    Likes Received:
    20
    theres a firmware for that, however it has been removed from the official github ...
     
  3. 3DogModeling

    3DogModeling Active Member

    Joined:
    Jun 22, 2016
    Messages:
    37
    Likes Received:
    3
    Or just swap the wire sets...thats the simple way and adjust your offsets the other way
     
  4. Alex9779

    Alex9779 Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    2,411
    Likes Received:
    735
    There was an official one? Where and when?

    As i explained in versions posts this won't work completely. It might look at first it does but you will face problems when printing at the limits of the bed...

    Start here https://forum.e3d-online.com/index....t-limits-and-mounting-options-explained.1404/
    An RC6 mirrored firmware for the Hybrid you can get at https://jenkins.alitecs.de
     
  5. Kenneth A Valentine

    Kenneth A Valentine Well-Known Member

    Joined:
    Feb 21, 2016
    Messages:
    103
    Likes Received:
    9
    Thanks for that will be back on it tomorrow Thankyou all
     

Share This Page