Material Flow Test

Discussion in 'Show off' started by Syko_Symatic, Jan 20, 2017.

  1. Syko_Symatic

    Syko_Symatic Well-Known Member

    Sep 4, 2015
    Likes Received:
    Just some pictures of a test piece I printed for work. It is to simulated the flow around a flange as a secondary fill.

    It was a while ago but if I remember rightly it was printed with the volcano 1mm nozzle in 0.5mm layers.

    Printed in 4 quarters it took around 6 hours per quarter.

    Spoon Unit likes this.

Share This Page