SOLVED Max Temp. of Heated Bed

Discussion in 'Calibration, Help, and Troubleshooting' started by Irawan Tri Kusumo, Jun 4, 2016.

  1. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    630
    Likes Received:
    101
    We're trying to help you - a resistance measurement would help us troubleshoot.

    I very much doubt PID gains are to blame.
     
  2. Irawan Tri Kusumo

    Irawan Tri Kusumo Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    116
    Likes Received:
    21
    @elmoret, thank you. Will tell you tomorrow about the resistance measurement.
     
  3. Irawan Tri Kusumo

    Irawan Tri Kusumo Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    116
    Likes Received:
    21
  4. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    630
    Likes Received:
    101
    Yes, assuming the meter is good. I'd contact E3D for replacement.
     
  5. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 7, 2014
    Messages:
    450
    Likes Received:
    93
    Unplug the wires then check the value again on the leads of the heated bed as well. Might be in the wiring
     
  6. Chase.Wichert

    Chase.Wichert Well-Known Member

    Joined:
    Mar 1, 2016
    Messages:
    775
    Likes Received:
    208
    I had that problem and ended up needing a new bed...
     
  7. Irawan Tri Kusumo

    Irawan Tri Kusumo Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    116
    Likes Received:
    21
    @elmoret , @Mike Kelly here another test directly to the bed... am I doing it right ? also with another multimeter.

    IMG_0779.JPG IMG_0781.JPG

    @elmoret , if you are doing a replacement can you send it together with an order that I just want to make ? any contact email that I could send so I will send the order number.
     
  8. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 7, 2014
    Messages:
    450
    Likes Received:
    93
  9. Irawan Tri Kusumo

    Irawan Tri Kusumo Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    116
    Likes Received:
    21
    @Mike Kelly , I am the one that should thank you, otherwise it could be just the cable and i will waste time by ordering another replacement if it is not bed's issue. Also thank you for the info.
     
  10. Irawan Tri Kusumo

    Irawan Tri Kusumo Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    116
    Likes Received:
    21
    I've never experienced like this before: my heated bed replacement is on the way to me, I will receive it in 3-4 days ... WOW, great service from E3D !!! Thanks !!
     

Share This Page