Might have a problem here

Discussion in 'E3D-v6 and Lite6' started by Montague Flange, Aug 9, 2016.

  1. Montague Flange

    Montague Flange Active Member

    Joined:
    Jul 10, 2016
    Messages:
    34
    Likes Received:
    6
    Had a replacement motor this week. Fixed it to the Y cable to test it and when I try to use it , IE: jog mode etc it just clicks. The motor that came with the Flashforge works fine though. Are the motors they send so different they won't work on a Mightyboard
     
  2. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    586
    Likes Received:
    91
    The wiring pinout may be different on different motors - you need all 4 wires in the place the driver expects to get movement.
     
  3. Montague Flange

    Montague Flange Active Member

    Joined:
    Jul 10, 2016
    Messages:
    34
    Likes Received:
    6
    I would have though all Neme 17 where wired the same. Oh well. Live and learn :)
     

Share This Page