Min_temp error on new install of E3D-V6

Discussion in 'E3D-v6 and Lite6' started by John Allen, May 26, 2018.

  1. John Allen

    John Allen New Member

    Joined:
    May 26, 2018
    Messages:
    1
    Likes Received:
    0
    Just installed a E3DV6 into my Robo R1 plus and I am ready to throw this against the wall. Getting a error for MinTemp and i was very careful with this thermistor. Did I get a lemon???
     
  2. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    731
    Likes Received:
    93
    Maybe you have to mention which controller and which temp sensor you are using?

    With the BigBox using the Rumba controller you need an interface board between the temp sensor and the controller. This may not be the case for you, but it would still be useful to know what each component is.

    And which (if any) E3D instructions you are following? (Lots of stuff on their WiKi)
     
  3. Antoine

    Antoine Well-Known Member
    Staff Member

    Joined:
    Apr 3, 2017
    Messages:
    117
    Likes Received:
    20

Share This Page