MINTEMP or MAXTEMP on initial power on

Discussion in 'BigBox General Chat' started by Spoon Unit, Mar 3, 2016.

  1. Spoon Unit

    Spoon Unit Well-Known Member

    Joined:
    Sep 6, 2015
    Messages:
    1,095
    Likes Received:
    322
    My dual is showing MAXTEMP instead of MINTEMP as per the guide. After a little discussion with Mike, looks like this is fine. It's because the initial power on test happens with only one side of the print head connected, thus one of the PT100s is not plugged in, and that generates the MAXTEMP. Hope that puts your mind at rest if you're seeing the same thing.
     
    Mike Kelly likes this.

Share This Page