Movable Platform Jack Test Print

Discussion in 'Show off' started by JohnEsc, Feb 15, 2016.

  1. JohnEsc

    JohnEsc Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    229
    Likes Received:
    144
    One of my 1st prints after completing the BigBox was to print this platform jack, however I was still very new to this and mistakenly printed it with Support, so it looked GREAT but did not move in any way as it was filled with support material! So, since I printed the Gear Hearts with decent results I wanted to try the platform jack print again. This time I printed it with raft to make sure it stuck to the bed... NEXT time I wouldn't do it with raft, just glue stick.
    [​IMG]
    http://www.thingiverse.com/make:195861
     

Share This Page