My first BigBox component

Discussion in 'BigBox General Chat' started by UlrichKliegis, Jan 31, 2016.

  1. UlrichKliegis

    UlrichKliegis Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    191
    Likes Received:
    48
    While waiting for my BigBox (we should create an acronym for that, w24myBB perhaps?) I thought, why not use the time for something productive? So I fired up my OrdBot Hadron and, having ordered two dual head BigBoxes, built the first set of parts for a single head printhead. PETG, 0.3mm E3D-V6, 0.2mm layers, 60% infill. S3D, cable bracket and clamps printed with support, removed already. Sorry, no banana, no hammer, no batteries..

    Observing the printing gave me an impressive impression of the engineering expertise that went into the construction. Cudos!


    printhead_20160131_0002.JPG
    printhead_20160131_0003.JPG
    printhead_20160131_0004.JPG
    printhead_20160131_0005.JPG
    printhead_20160131_0006.JPG
    printhead_20160131_0007.JPG
    printhead_20160131_0008.JPG
    printhead_20160131_0009.JPG
     
    Pierce, Mike Kelly and mike01hu like this.
  2. mike01hu

    mike01hu Well-Known Member

    Joined:
    Apr 22, 2014
    Messages:
    957
    Likes Received:
    167
    I left my commendation on G+ Ulli. These are complex prints with lots of reliance on bridging and overhangs being good. Yours look fine but a little pink ;-)

    Mike
     
  3. Kanedias

    Kanedias Well-Known Member

    Joined:
    Sep 12, 2015
    Messages:
    408
    Likes Received:
    124
    Striking colour. :cool:

    I'm starting to print the guide piece/Stepper mount myself to try and work out a way to mount a filament detector. The anticipation is killing me.
     
    mike01hu likes this.

Share This Page