Hi all I was given a cubex and want to start 3D printing but the printer I was given the hot end has snapped around the heat sink I was wondering what would be a good replacement if there is any ? Cubify 401383 CubeX Single Head 3D Printer
I have had a quick look online, I haven't been able to quite see the HotEnd/ Extruder set up on that particular printer, however, in general, my suggestions would be to either look at a Hemera for a direct drive setup, and a Hemera/ V6 for a Bowden set up. We don't currently have any printer-specific guides for the CubeX unfortunately. Our typical recommendation in this situation would be to have a look at file-sharing websites such as thingiverse.com for pre-existing guides, alternatively, you can design your own mount based on the drawings available on our Dozuki page: https://e3d-online.dozuki.com/
