New nozzle location in firmware

Discussion in 'E3D-v6 and Lite6' started by MichaelK, Jan 1, 2019.

  1. MichaelK

    MichaelK New Member

    Joined:
    Jan 1, 2019
    Messages:
    1
    Likes Received:
    0
    After I install a v6 hotend on my cr-10s, do I need to change the firmware to define the new Y axis offset for the nozzle ?

    Regards
    MichaelK
     
  2. Antoine

    Antoine Well-Known Member
    Staff Member

    Joined:
    Apr 3, 2017
    Messages:
    117
    Likes Received:
    20
    You will need to change the frmware to modify other parameters which are all outlined here: https://e3d-online.dozuki.com/c/V6_Firmware_Guides
    The nozzle location will depend on your particular setup, as we do not directly provide an upgrade kit for this.
     

Share This Page