New user help with duel v.1.1 hybrid

Discussion in 'Calibration, Help, and Troubleshooting' started by matt hanson, Jan 21, 2018.

  1. matt hanson

    matt hanson Member

    Joined:
    Jan 21, 2018
    Messages:
    16
    Likes Received:
    1
    Hello everyone, just picked up a used bigbox v1.1 hybrid duel titan model and can't for the life of me figure out how to set up the s3d profile. I can print duel colors just fine but how do I go about using only one material without having the other hot end heated or loaded with material.
     
  2. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    731
    Likes Received:
    93
    Main screen top right choose e.g. Left Extruder Only

    Extruder tab Extruder Toolhead Index " Tool 0"

    Layer tab Primary Extruder Left Extruder

    Additions tab Skirt Extruder Left Extruder

    Infill tab Infill Left Extruder

    Support tab (as above if you select this tab I assume right extruder :) )

    Temperature tab............ On the left just have Left extruder and heated bed ONLY.

    When you highlight either on the left the Temperature Identifier on the right should read T0

    I have probably missed some (and some such as "Index" may have other purposes but the theory is the same when choosing say "Left Extruder".

    Particularly important is the Temperature tab settings.

     
  3. matt hanson

    matt hanson Member

    Joined:
    Jan 21, 2018
    Messages:
    16
    Likes Received:
    1
    Ty for the response. I was doing all that but was having an issue with getting one nozzle to heat up. It ended up being a loose connector that must have bounced loose when i was transporting the unit home.
     

Share This Page