Ninjaflex SemiFlex

Discussion in 'Show off' started by Tony Morel, Apr 3, 2016.

  1. Tony Morel

    Tony Morel Active Member

    Joined:
    Sep 5, 2015
    Messages:
    27
    Likes Received:
    9
    First attempt with Ninjaflex's SemiFlex and I'm over the moon.
    This material was always a no-go on my previous 3D printers so even tho I need to seriously tweak the settings I just want to say I love everyone at E3D.

    image.jpg
     
    #1 Tony Morel, Apr 3, 2016
    Last edited: Apr 3, 2016
    Rob Heinzonly, PsyVision, Alex9779 and 1 other person like this.
  2. Henry feldman

    Henry feldman Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    969
    Likes Received:
    391
    What settings were you using?
     
    #2 Henry feldman, Apr 3, 2016
  3. Rob Heinzonly

    Rob Heinzonly Well-Known Member

    Joined:
    Sep 20, 2015
    Messages:
    447
    Likes Received:
    173
    That sure looks good 1 What are your feed settings ? Did you adjust them ?
     
    #3 Rob Heinzonly, Apr 3, 2016
  4. Tony Morel

    Tony Morel Active Member

    Joined:
    Sep 5, 2015
    Messages:
    27
    Likes Received:
    9
    Well I just noticed my funpack had the wrong nozzles, then realised it was probably more likely that I'd put the wrong nozzle on the printer.
    Was a dot out, will redo my redone settings *ooops*
     
    #4 Tony Morel, Apr 4, 2016
(You must log in or sign up to post here.)

Share This Page